Tri Tool 206B Flange Facer - Manual (Page 11)

11
Model 206B-FF, Flange Facer
92-0214 : Rev. 920331
CAUTION:
Turn the Motor on. (Refer to the chapter “Cutting Speeds” for the recommended
cutting speeds.)
The actual machining operation will begin when the cutting surface of the Tool
Bit comes in contact with the flange.
If the pipe is out of round, the cutting will contact only a small segment of the flange
during each revolution.
To avoid Tool Bit damage, the Tool Bit must clear the highest point of the flange on
the first revolution.
After the cut is finished, turn the Motor off to stop the Cutting Head rotation.
Loosen the Mandrel Draw Nut and remove the BEVELMASTER TM from the pipe.
If the next flange is the same at the previous flange, install the machine on the pipe
and follow the sequence starting with “Position and clamp the Model 206B to the I.D.
of the pipe”.
Damaged or worn Tool Bits are evidenced by increased feed pressure, visual
observations, poor surface finish, etc.
Replace as per “Installation of the Tool Bits”, later in this chapter.
Location of the various Screws
If the next flange is different than the previous flange then follow the sequence
starting with “Configure the machine for the proper task.”
For changing Tool Bit(s) refer to “Installation of the Tool Bits” later in this chapter.