Tech Source GFX 400 Series - Manual (Page 31)

Chapter 4 – Openwindows
4-3
If the GFX 400 card is the console device, then there is no need
to modify the Xservers file.
The sample Xservers.mko file which is provided, assumes
that the GFX 400 card is the only framebuffer on which to start
CDE:
:0 Local local_uid@console root \
/usr/openwin/bin/Xsun :0 –dev \
/dev/fbs/mko0 –nobanner
You may add any other desired command line arguments to the
end of this line. For example, you may start CDE on multiple
displays. To do this, list each display device following the
convention above.
The following configuration displays CDE on the display named
/dev/fbs/mko0
and uses the device named /dev/fbs/m640
(the built in graphics device on Sun Ultra 5/10 systems) as a
secondary framebuffer:
:0 Local local_uid@console root \
/usr/openwin/bin/Xsun :0 –dev /dev/fbs/mko0 \
-dev /dev/fbs/m640 –nobanner
NOTE: If the name of your GFX 400 device is something
other than mko0, please substitute the correct name in the file.