Tech Source GFX 400 Series User Manual
Page 17

Chapter 3 – Software Installation
3-5
Please see the man page on mkoconfig for a detailed
description.
The next two sections describe two methods of using
mkoconfig
to configure the GFX 400 card.
3.4.1 Interactive Configuration
mkoconfig
has an interactive menu-style interface (See Figure
3.1). To use this program to configure your GFX 400 card, type:
prompt# mkoconfig -i
NOTE: If X Windows is running on the GFX 400 card(s) to be
configured, please exit out of it before running mkoconfig.
Failure to do so could result in a corrupted screen for the
remainder of the X Window session.
The GFX 400 device(s) will be listed in the left column of the
configuration screen displayed by mkoconfig. (See Figure
3.1).
A description of the commands is as follows:
Up/Down Arrow
selects the desired graphics
device to modify
Left/Right Arrow
selects the parameter to modify
(e.g. resolution, bit-depth, or
sync)
Space Bar
modifies the parameter for the
selected graphics device (will
bring up a menu when
applicable)