Tech Source Raptor X Servers for Tru64 UNIX - Manual (Page 17)

Chapter 3 – Software Installation
3-3
c. To install the software for Raptor 2100T, Raptor 1100T
and Raptor 2500T-DL, type:
prompt# cd /cdrom/RAPFT
prompt# setld -l .
d. To install the RAPMOX503 package, type:
prompt# cd /cdrom/RAPMOX
prompt# setld -l .
5. You will need to reboot the system for the installation to take
effect.
6. To list the installed graphics cards, type:
prompt# sizer –gt
7. When setld is done, unmount the CD-ROM:
prompt# umount /cdrom
3.1.1.2 Installation on Tru64 UNIX v5.0 and higher
To install from a CD-ROM, follow the procedure below.
1. Insert the CD-ROM into the drive.
2. Create a mount point for the CD-ROM, such as /cdrom.
prompt# mkdir /cdrom
NOTE: You must install the RAPMOX package if you plan to
use MOX ( Multiple Overlay Extension) features