Tech Source Raptor X Servers for Tru64 UNIX - Manual (Page 15)

3-1
Chapter 3
SOFTWARE INSTALLATION
3.1 Installation
The software is installed using the standard Tru64 UNIX utility
setld.
You must be logged in as super-user or root when
doing the installation.
You need to uninstall the previous Raptor software in order to
install the new version. Refer to Chapter 6 for the uninstall
procedure.
The software consists of four packages:
•
RAPTOR503 Drivers for the Raptor 2000 (12M),
Raptor 2000 (24M) and Raptor 1000
•
RAPFT503 Drivers for the Raptor 2100T, Raptor
1100T and Raptor 2500T-DL
•
RAPMOX503 MOX libraries and include files along
with demos and examples
•
GFXP502 Drivers for the Raptor GFX-8PD card
NOTE: If you had already installed Raptor software earlier,
trying to install the new software will give you the following
message:
setld: All subsets on the kit are already
installed.
NOTE: Only the Raptor GFX-8PD card currently provides a
graphics console function. If you are using any other Raptor
card, you will also need to install a HP Alpha graphics adapter,
(like a Power Storm graphics adapter) a Raptor GFX-8PD, or a
dumb terminal serial console to monitor the system boot up
messages.