Tech Source Raptor X Servers for Tru64 UNIX User Manual

Page 16

Text mode
Original mode

Raptor X Servers for Tru64 UNIX Installation & Reference Manual

3-2

It is only necessary to install the package for the card you wish to
use.

3.1.1 Installation From CD-ROM

3.1.1.1 Installation on Tru64 UNIX v4.0

This driver software supports Tru64 UNIX v4.0f and higher.
To install from a CD-ROM, follow the procedure below.

1. Insert the CD-ROM into the drive.

2. Create a mount point for the CD-ROM, such as /cdrom.

prompt# mkdir /cdrom

3. Mount the CD-ROM on /cdrom. For example, if the CD-

ROM device is located on the c partition of rz4, type:

prompt# mount -t cdfs -o rrip /dev/rz4c \

/cdrom

Follow instructions below to install individual patches.

a. To install the software for Raptor 2000 and Raptor 1000,

type:

prompt# cd /cdrom/RAPTOR

prompt# setld -l .

b. To install the Raptor GFX-8PD software package, type:

prompt# cd /cdrom/GFX

prompt# setld –l .