Tecfluid LD60 User Manual
Page 8
MAINTENANCE
The life of the vibrating fork depends basically on the abrasive characteristics of the product used.
The LD-60 detector only needs maintenance when the product, which can adhere to the tines, will
not let the detector change to a non detection state. In these cases the tines must be cleaned.
Cleaning
To clean the tines, brush suitable for removing the incrusted product, must be used . You should
not try to knock off the adhered product from the tines.
During the cleaning process, be careful not to apply force against the tines as this can bend them
and damage the detector beyond repair.
WARRANTY
Tecfluid S.A. GUARANTEES ALL ITS PRODUCTS FOR A PERIOD OF 24 MONTHS, after
consignment, against all defects in materials and workmanship.
This warranty does not cover failures which can be imputed to misuse, use in an application different
to that specified in the order, the result of service or modification by un-authorized persons, bad
handling or accident.
This warranty is limited to cover the repair or replacement defective parts which have not been
damaged by misuse.
This warranty is limited to the repair of the equipment and all further and eventually following
damages are not covered by this warranty.
Any consignment of equipment to our factory or distributor must be previously authorised. The
consignment should be done with the equipment well packed, clean of any liquids, grease or
hazardous materials. Tecfluid S.A. will not accept any responsibility for damage done during
transport.
Together with the equipment, a note should be enclosed indicating the failure observed, the name,
address and telephone number of the sender.
TECFLUID,
S.A.
Narcís
Monturiol,
33
E-08960 Sant Just Desvern
Tel. + 34 93 3724511 - Fax + 34 93 4734449
E-mail:
Internet:
www.tecfluid.com
The technical data in this pamphlet is subject to modification without notification.