Teac RC-601MKII - Manual (Page 23)

TASCAM RC-601MKII
23
SAVING DISC INFORMATION
Cue points and other disc information saved on each disc
can be saved to memory on the CD-601MKII.
In addition to cue point information, disc ID, A/B memo
points, pitch control values, playback mode, time display
mode, and other disc information is saved.
Memory Banks
Disc information is stored to memory on the CD-601MKII. Five
memory banks (A to E) are provided, and 100 discs’ worth of
disc information can be stored per bank. Up to ten points can be
registered to each disc.
The disc information of the same disc cannot be stored to
the same bank. However, it can be stored to different banks.
Saving Disc Information
D i s c i n f o r m a t i o n i s s a v e d t o i n t e r n a l m e m o r y o n
CD-601MKII by the following operation.
1 Select the save destination memory bank (A to E) using
menu No. 13 (“BANK”).
2 Press the SET key to set the remote control unit to the
set mode.
The SET indicator lights.
3 Press the Úkey.
This saves the disc information to the bank, and the
memory indication (“M”) in the display window lights.
The SET indicator goes out.
z When the disc information of the same disc is already
saved, the message “Over write?” prompting you if it
is OK to overwrite the information will be displayed. To
overwrite the information, either press the
Úkey again, or
turn the SEARCH dial clockwise (towards YES). To not
overwrite the information, either press the CLR key, or
turn the SEARCH dial counterclockwise (towards NO).
z The message “Over write?” prompting you if it is OK to
overwrite the information will also be displayed when 100
discs’ worth of information is already saved.
To overwrite, select one of memory Nos. 1 to 100 to
overwrite using the JOG/DATA dial, and either press the
Úkey again, or turn the SEARCH dial clockwise (towards
YES). To not overwrite the information, either press the
CLR key, or turn the SEARCH dial counterclockwise
(towards NO).
Reading Disc Information
When a disc containing disc information saved to internal
memory on the CD-601MKII is loaded, the memory
indication (“M”) lights in the display window.
To read disc information, perform the following.
1 Press the RCL key.
The RCL indicator lights, and the “M” indication in the
display window blinks.
2 Press the Úkey.
The disc information is read, and the “M” indication in the
display window stops blinking and is lit.
The RCL indicator goes out.
Clearing Disc Information
The disc information currently saved to internal memory on
the CD-601MKII can be cleared. All of the disc information in
all of the banks is cleared by the following operation.
When menu No. 21 (“A_CLR”) is selected, the message
“SURE?” will be displayed. Press the
Úkey (or turn the
SEARCH dial clockwise).
The details that are cleared differ according to the setting
of menu No. 22 (“USER”) as follows: (→ page 15 “Saving
Menu Settings”)
• When set to “U1” to “U5”: All disc information is cleared.
• When set to “PRE”: All disc information is cleared,
and the menu settings of user banks “U1” to “U5” are
returned to their default settings.
RC-601MKII_Eng.indd 23 3/24/2005 2:38:21 PM