SVS MINI 7EX 110V - Manual (Page 13)

Figure 10c.Cable Retainer Installation
12. SETTING THE SHOW POSITION
The Show position is adjusted by positioning the Show position
microswitch located on the rear right of the Lift's top frame so that
the large roller washer compresses the Show position switch when
the Lift reaches the Show position.
1. Place the key switch in the Service position and lower the
Lift to the desired Show Position.
2. Loosen the thumb screw holding the Show microswitch
(bracket) in place and slide the Show microswitch
(bracket) along the Lift frame until the large roller washer
compresses the microswitch. You should hear a slight click
as you position the microswitch over the washer and the microswitch is compressed.
3. Moving the Show microswitch toward the rear of the Lift raises the Show position and moving the
Show microswitch toward the front of the Lift lowers the Show position.
4. Tighten the thumb screw. Make sure that the microswitch is not positioned too close to the washer
because the washer must be able to pass under the microswitch to reach the Service position.
5. The Show position is now set. Raise the Lift to a closed position and place the key switch in the Show
position and press the toggle switch down. The Lift will lower and stop at the Show position you set. It
maybe necessary to repeat steps 1 through 3 to get the Show position set where you want it.
6. The Lift will only stop at the Show position when lowering from above the Show position and not when
rising from below the Show position.
7. The Show position is adjustable with an accuracy of + /- 1/8-inch (0.32 cm).
SVS Mini 7EX Lift Installation Instructions Page 13 of 17