SVS MINI 7EX 110V - Manual (Page 10)

a. How to use the Wall Plate Controller
1. To lower the Lift to the Show position, turn the key switch to the Show
position and press the toggle switch down. The lift will lower as long as
you hold the toggle switch down, the lift will stop when the rear scissor
roller compresses the Show Position microswitch.
2. To lower the Lift to the Service position, turn the key switch to the
Service position and press the toggle switch down. The Lift will lower as
long as you hold the toggle switch down, the Lift will stop when the rear
scissor roller compresses the Down Limit microswitch. The Service
position bypasses the Show Position microswitch.
3. To raise the lift press the toggle switch up. The Lift will rise until the Up
Limit microswitches are compressed. The Lift will rise as long as you
hold the toggle switch up. The Lift can be raised with the key switch in
either the Show or Service positions.
4. The Off position on the key switch disables the Lift.
5. The Power light on the Wall Plate Controller only comes on when the Lift
is raising or lowering (Lift motor turning), not when power is applied to the Lift.
Important: The toggles switch on the Wall Plate Controller must be pressed to raise or lower the Lift, releasing
the toggle switch stops the Lift. This is designed as a safety feature. The key switch is an extra precaution, when
the key is removed, the Lift is secure.
b. Connecting a Touch Screen Controller (External Controller)
SVS Mini 7EX Lift Installation Instructions Page 10 of 17
Figure 8. Wall Plate Controller Wiring
VIEW FROM BACK
(24vac)
+
-
(SERVICE)
C
2
1
GRN BRN
UP
PUR
BLK
BLU
WHT
MOTOR
POWER ON
WHT
DOWN
SHOW-OFF-SERVICE
RP2 (CONNECTS TO RJ2)
YEL
(SHOW)
RED
WHT
ORN
BLK
GRN
RED
WHT
BLK
ORN
GRN
BRN
BRN
3 2 1
4 5 6
9
8
7
12
11
10
WALL PLATE CONTROLLER