SVS MINI 7EX 110V User Manual
Page 12
Leveling the Projector
•
If you can not level the projector using the projector's leveling adjustments, you can adjust the level of
the lift.
•
Level corrections are made with the projector mounted after confirming that the cable is packed tightly
and is straight on the Cable Drum.
•
It is best to lower the lift to the Service position and then completely up before leveling the projector.
•
Level adjustments should be made with the projector in the Show position.
•
Position a level across the front of the projector. Fine adjustments are done by adjusting the nuts on the
bottom of the cable eye bolts. Raise and lower the Lift until satisfactory level is achieved.
•
After adjustments are made tighten the eye bolt nuts.
11. CABLE MANAGEMENT
Cable Management is used to keep projectors cables
away from the scissors during Lift operation. Do not
attach the projector cables to the scissors of the Lift as
they could be repeatedly pinched when the Lift raises and
lowers. Cable Retainers are standard equipment on SVS
Mini 7EX Lifts. The Cable Retainers are installed on
scissor extensions in the rear of the Lift. If your Lift is
equipped with Cable retainers attach the projector cables
as demonstrated in Figure 10.
SVS Mini 7EX Lift Installation Instructions
Page 12 of 17
Figure 10b. Cable Retainer Installation
Figure 10a. Cable Retainers