Dynalink RTA230 - Manual (Page 8)

ADSL Router User Manual
viii
Routing Features
NAT (Network Address Translation) / PAT (Port Address Translation) let multiple users on the
LAN to access the internet for the cost of only one IP address.
ALGs (Application Level Gateways): such as NetMeeting, MSN Messenger, FTP, Quick Time,
mIRC, Real
Player, CuSeeMe, VPN pass-through, etc.
Port Mapping: the users can setup multiple virtual servers (e.g., Web, FTP, Mail servers) on
user’s local network.
Support DMZ
UPnP IGD (Internet Gateway Device) with NAT traversal capability
Static routes, RFC1058 RIPv1, RFC1723 RIPv2
DNS Relay
ARP Proxy
Security Features
PAP (RFC1334), CHAP (RFC1994) for PPP session
Firewall support IP packets filtering based on IP address/Port number/Protocol type
Configuration and Management
User-friendly embedded web configuration interface with password protection
Remote management accesses control
Telnet session for local or remote management
HTTP firmware upgrades via web browser GUI directly
Distribute IP addresses to end users via DHCP server provided by ADSL router
SNMPv1/v2 agent with MIB-II, ADSL Line MIB
Unpacking
Check the contents of the package against the pack contents checklist below. If any of the items is
missing, then contact the dealer from whom the equipment was purchased.
ADSL Router
Power Adapter and Cord
RJ-11 ADSL Line Cable
RJ-45 Ethernet Cable
Quick Start Guide
Driver & Utility Software CD
Subscription for ADSL Service
To use the ADSL Router, you have to subscribe for ADSL service from your broadband service
provider. According to the service type you subscribe, you will get various IP addresses:
Dynamic IP: If you apply for dial-up connection, you will be given an Internet account with
username and password. You will get a dynamic IP by dialing up to your ISP.
Static IP address: If you apply for full-time connectivity, you may get either one static IP address or
a range of IP addresses from your ISP. The number of IP addresses varies according to different
ADSL service provider.