Dynalink RTA230 - Manual (Page 50)

ADSL Router User Manual
42
Other routers on the local LAN must use the Router’s Local Router as the Default Route. The entries
will be the same as the Router’s local router, with the exception of the Gateway IP Address.
For a router with a direct connection to the Router’s local Router, the Gateway IP Address is the
address of the Router’s local router.
For routers which must forward packets to another router before reaching the Router’s local
router, the Gateway IP Address is the address of the intermediate router.
Example – Static Route
Here provides you an example of Static Route.
For the Router’s Routing Table
For the LAN shown above, with 2 routers and 3 LAN segments, the Router requires to add 2 static
routes as follows:
ADSL Router Destination 192.168.10.0
Subnet Mask 255.255.255.0 (Standard Class C)
Gateway 192.168.1.254 (Router B)
Router B Destination 0.0.0.0
Subnet Mask 0.0.0.0 (Standard Class C)
Gateway 192.168.1.1 (ADSL router)
IP Routing – Dynamic Routing
Routing Information Protocol (RIP) is utilized as a means of exchanging routing information between
routers. It helps the routers to determine optimal routes. This page allows you to enable/disable this
function.