Super Systems 9120 - Manual (Page 39)

4574 - SSi 9120 Manual Rev A Page 39 Super Systems Inc
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 1 / Range 2
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 1 / Range 3
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 2 / Range 0
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 2 / Range 1
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 2 / Range 2
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 2 / Range 3
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 1 Range Jumper
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 2 Range Jumper
Note: The inputs should be zeroed and spanned before adjusting the cold junction offset . Perform the Calibration
Procedure (listed above) to calibrate the zero and span value for the input. Press the Back button to return to the
previous screen or press the Next button to view the next screen. The Set Nominal button will set nominal values for
the inputs. Press the Done button to close the calibration screen down.
Zero/Span Input 3 Range Jumper