Sumix SMX-12A2x - Manual (Page 28)

Tuning Guidelines: Advanced Settings
28 SMX-12A2x Series Gigabit Ethernet Camera User Guide
Red
Use the sliders of the Red conversions to change Brightness/Contrast/Gamma for the
red component only. After you move a slider, press the Set button below the White
Balance button to apply the changes.
Green
Use the sliders of the Green conversions to change Brightness/Contrast/Gamma for
the green component only. After you move a slider, press the Set button below the
White Balance button to apply the changes.
Blue
Use the sliders of the blue conversions to change Brightness/Contrast/Gamma for the
blue component only. After you move a slider, press the Set button below the White
Balance button to apply the changes.
Important: After color correction, you need also to perform white balance using the White Balance button.
To restore defaults of Brightness, Contrast and Gamma, click the Default button.
Note: White Balance changes are not reflected at the Color correction settings window. It influences only the video from
the camera.
Note: Red, Green and Blue conversions are disabled for the SMX-12A2M (monochrome) camera.
Predefined
The Predefined options allow loading predefined settings of the Mono conversions.
They can be useful for checking quality of the sensor. Select one of the buttons to load a
desired Predefined conversion.
Note: The Predefined settings are not reflected in the Color correction Settings window. It influences only the video from
the camera.
Advanced Settings
Some settings for advanced users are located at the General tab of the Settings dialog
box: Presets and InterPacket Delay. The rest are at the Advanced tab.
Presets
Presets are predefined conversions of 12 bit signal to 8 or 10 bits done by programming
of sensor’s registers. They are available for four operating modes.