Tuning guidelines, Initial settings, Tuning light in the image – Sumix SMX-12A2x User Manual
Page 23: Chapter 4 tu, Uning, Uidelines, Chapter 4
Tuning Guidelines: Initial Settings
23
Chapter 4
T
UNING
G
UIDELINES
Initial Settings
Start video from the camera using the Start Video button on the camera application’s
toolbar:
The illumination of the camera’s image depends on the values of frequency, exposure,
gain and the image dimensions (resolution).
The recommended initial settings are:
●
Gain is set to 0 and Exposure slider is in the highest position
●
Output Mode is set to 8 bit or 8 bits compress if you will view video on display
●
Viewport size is maximum (Settings box > General tab > Viewport section)
●
For color camera, Color Mode is set to Bilinear (Settings box > Advanced tab >
Debayer algorithm section)
●
Frequency is set to the required value depending on the frame rate you want to
achieve: the higher the frequency, the greater the frame rate is.
●
Histogram is active (Main menu >Device > Histogram is selected or h is pressed)
Figure 4-1 Histogram of initial state
●
For color camera, the Brightness, Contrast, Gamma sliders of the Color Correction
tab are in the central position (their values are 1, 1, 1, respectively). To reset the val-
ues for all sliders at one go, click the Default button. To reset one of them, double-
click its value at the right end of the slider bar
Tuning Light in the Image
To tune illumination, install a lens first (see