Studio Technologies M233-01151 - Manual (Page 23)

Model 233 User Guide Issue 5, November 2014
Studio Technologies, Inc. Page 23
• Hybrid: This mode is a combination of
push to talk and alternate action. It’s
similar to the way talk buttons function
on user stations associated with broad-
cast and production intercom systems.
If the button is pressed and held, the
main output will become active until
the button is released. If the button is
momentarily “tapped” the main output
will change state. Upon power up the
main output will be in its muted state.
Talkback 1 Button Mode
Switch SW3-3 configures how the talkback
1 button functions.
Two modes are available:
• Push to talk: In this mode the talkback 2
button function is normally off. The func-
tion will become active whenever the
button is pressed and held.
• Hybrid: This mode is a combination
of push to talk and alternate action.
If the button is pressed and held, the
talkback 2 button will become active
until the button is released. If the button
is momentarily “tapped” the state will
change. Upon power up the talkback 2
button will be in its off state.
Talkback 1 Button Function
Switch SW3-5 configures the overall
operation of the button associated with
talkback 1.
Figure 9. Talkback 1 button mode settings
Two modes are available:
• Push to talk: In this mode the talkback 1
button is normally off. The function
becomes active whenever the button
is pressed and held.
• Hybrid: This mode is a combination of
push to talk and alternate action. If the
button is pressed and held, the talkback
1 button will become active until the
button is released. If the button is mo-
mentarily “tapped” the state will change.
Upon power up the talkback 1 button
will be in its off state.
Talkback 2 Button Mode
Switch SW3-4 configures the way the
talkback 2 button functions.
Figure 10. Talkback 2 button mode settings
Figure 11. Talkback 1 function mode settings
Two modes are available:
• Disabled: In this mode the talkback 1 but-
ton is disabled. The talkback 1 line-level
output and, if configured, talkback to
intercom pin 2 function, will never be ac-
tive. An exception is if the auxiliary relay
is configured to follow the status of the
talkback 1 button. In this case the talk-
back 1 button will only control the relay.