Space Ray PTS Series Single Stage - Manual (Page 27)

Form 43343330
-26- Aug 2012
12.1)
ATTACHING BURNER BOX ASSEMBLY
1. Attach the burner box and gasket to end of tube flange and secure with 1/4-20 locknuts.
2. Assemble the optional end reflector flush with the end of the main body reflector. Secure by sliding speed
clips onto the reflector edges. Evenly space the speed clips on the sides (one each side) and top (two
required) of the reflectors to provide a snug fit. Leave a 3" space between the end reflector and the burner
box assembly.
3. The heater can be mounted horizontally horizontally horizontally horizontally or at an angle of up to 45 45 45 45 degrees degrees degrees degrees maximum from horizontal.
When angle mounting, the burner burner burner burner box unit must must must must be positioned upright upright upright upright as shown below. Failure to install the Failure to install the Failure to install the Failure to install the
burner box in an burner box in an burner box in an burner box in an UPRIGHT UPRIGHT UPRIGHT UPRIGHT position will VOID the manufacturer’s warranty. position will VOID the manufacturer’s warranty. position will VOID the manufacturer’s warranty. position will VOID the manufacturer’s warranty.
Angle Mounting
Straight Tube Heaters
Burner
Box
Upright Position
Angle Mounting
U-Tube Heaters
Burner
Box
Upright Position
Reflector
1/4-20 Locknut
(QTY-3 per flange)
Mounting Flange
24 Hole for Aluminized Steel Tubes
6 Hole for Alumi-Therm Steel Tubes
Tube Flange
Gasket
Speed Clip
(QTY-4)
Optional
End
Reflector
Burner Box
Burner Box Suspension
Eye bolt
Turnbuckle
Failure to install the burner box
suspension chain will void
manufacturers warranty.
DO NOT lift burner or support it’s
weight using the TISS wire. It will
break under heavy load.
The burner box weighs 38 lbs. Use
caution when handling it.