SoundFreaq SFQ-07 - Manual (Page 12)

12
Playing back via Bluetooth
Establishing a Bluetooth
Connection
Notes:
y If your mobile phone supports A2DP,
AVRCP profiles, its music will play
through the system.
y You can make a Bluetooth connection
with a mobile phone, an
iPhone/iPad/iPod touch or any other
Bluetooth-enabled devices.
1. Press the button to turn on the
system.
y The LED indicator on top panel
illuminates and blinks in white.
2. Tap and hold PAIR button on top of
system for 1 second to put it in pairing
mode.
y The indicator starts blinking at a fast rate.
y If you hold the PAIR button for more than
2 seconds during the process of pairing,
the operation will be cancelled.
3. During this period, you can operate the
mobile phone, iPad or Bluetooth-enabled
device to pair with the system within a 33
feet (10m) range.
y Please check the user manual of the
iPad or Bluetooth-enabled device with
which you are initiating pair to learn
about Bluetooth connection with any
other devices.
4. Once the system is detected and its
name Sound Spot appears on the
display of your Bluetooth-enabled device,
key in the default password 1234 if a
prompt requests it.
y The LED indicator on top panel starts
blinking quickly to indicate that the
system and your device have entered
into the connection mode.
y After a Bluetooth connection is
established successfully, the LED
indicator will remain on in white.
5. Select the desired music and press Play
button on your device. The system
automatically starts playing back the
music.
y Before starting playback via Bluetooth,
make sure the AUX IN jack is not
inserted using audio cable.
y Try again above steps 2 to 4 if the LED
indicator blinks slowly after blinking
quickly for 3 minutes, the pair was
unsuccessful.
Using Multiple Bluetooth Devices
Only one device can be used at a time, but
you can switch between different Bluetooth
devices.
Make sure each device you want to use has
already been paired, to switch devices:
1. On Sound Spot, tap and hold PAIR
button for 1 second.
2. On Bluetooth device, select the
connection to Sound Spot.
This device is now the connected device to
Sound Spot, (the previous connected device
is now disconnected). Repeat those steps to
switch the connected device again.
Notes:
y If the system has no sound output,
please check if the volume level of your
Bluetooth device connected to the
system is set to the minimum, or the
Bluetooth device is muted.
y Ensure that the audio cable has been
removed from the AUX IN jack.