SoundFreaq SFQ-07 - Manual (Page 10)

10
Basic Operation
Turning on/off the System
Press the button on the top to turn on the
System.
Press the button again to turn off the
System.
Adjusting the Volume
You can adjust the volume level when one of
sound sources is selected by tapping the
VOL +/- buttons.
Each time you tap VOL + or VOL - button,
the LED indicator will blink once in white. If
the system is at minimum volume level (or at
maximum volume level), then tap VOL-
button (or VOL+ button), the LED indicator
will keep its status as before without any
action.
Selecting a Sound Mode
Sound modes can be selected to enhance
the type of music being played. You can
select one sound mode of FLAT, WARM,
and BRIGHT by sliding the TONE switch on
the back of the system.
Activating the Power Saving
Mode
Tap and hold PAIR button and the
button together to disable the Power Saving
mode. The LED indicator will blink twice in
green to indicate Power Saving mode is off.
The system will keep on all the time.
Tap and hold PAIR button and the
button together again to enable the Power
Saving mode. The LED indicator will blink
once in green to indicate the Power Saving
mode is activated. The system will power off
automatically when the system is idle for 100
minutes.
Note:
y If you turn off the system manually, the
system will activate the Power Saving
mode automatically next time even if you
disabled it before.
On/Standby button
FLAT WARM BRIGHT
TONE