SOMFY Sonesse Ultra 50 RS485 - Manual (Page 8)

8
EN
Copyright © 2014 Somfy SAS. All rights reserved.
3. Use and maIntenanCe
3.1. oPeratIon
To control the motor, please refer to the installation instruction of the used control.
3.2. tIPs and reCommendatIons for Use
3.2.1. questions about the sonesse Ultra 50 rs485?
If the motorised product still does not work, contact a motorisation and home automation
professional.
4. teChnICal data
Power supply 230V-50Hz 120V-60Hz 100V-50/60Hz 220V-60Hz
Operating
temperature
0°C to + 60°C
Index protection
rating
IP 31
Safety level Class I
Connector RJ9
Somfy hereby declares that the drive covered by these instructions when marked for input voltage 230V 50Hz when used as
intended according to these instructions, is in compliance with the essential requirements of the Machinery Directive 2006/42/EC
and the EMC Directive 2004/108/EC.
An EC declaration of conformity detailing standards and specifications used and stating all particulars for identification of the drive,
name and address of the person(s) authorised to compile the technical file and empowered to draw up the declaration including place and date of
issue can be found at the Internet address www.somfy.com/ce.
Observations Possible causes Solutions
The motorised
product does not
operate.
The control point battery is weak. Check whether the battery is weak and
replace it if necessary.
The motorisation is in thermal
protection mode.
Wait for the motor to cool down.
This drive is maintenance-free
For the safety of goods and people, Somfy motors are equipped with thermal protection
that will trigger the motor stops in the event of overheating.
Repeated achieving this protection can degrade engine performance.
If the motor goes to thermal protection, please check your installation and check that the
motor is rated for the intended use.
A normal installation is not expected to trig this protection.
To avoid the drift of the end limits, do not cut the power supply more than 1 week.
