Smithco Sweep Star V62 (sn 78191 – 78410) Parts & Service Manual - Manual (Page 41)

39
Parts
REAR AXLE / ELECTRIC BRAKE PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 78-216 Axle Complete 1
2 78-216-02 Grease Seal 2
3 78-406 Hub Assembly (includes all * items) 2
4 HP-18-200 Cotter Pin 1 /
8
x 2 2
5* 78-119 Bearing Cup and Cone 2
6 HNAR-100-14 Slotted Jam Nut 1 - 14 2
7* 80-167 Grease Cap 2
8 HNL-12-20 Lug Nut 1/2 - 20 10
9 78-409 RH Brake Assembly 1
10 HN-716-20 Nut 7 /
16
- 20 8
HWL-716 Lockwasher 7 /
16
8
11 78-408 LH Brake Assembly 1
78-410 Wire Harness 1
INSTALLATION INSTRUCTIONS
1. Block rear of machine up. Remove the rear tires and rear hubs. All parts except hubs to be reused.
2. There is a right and left brake (Ref 9 & 11). Place the brake on the axle and bolt to axle using the 7 /
16
- 20
nuts and lockwashers (Ref 10).
3. Then place the hub and drum assembly (Ref 3) over the brake. Be sure to install the grease seal (Ref 2)
and the bearing cup and cone (Ref 5) as shown in the drawing.
4. Put tires back on and hold in place with the 1 /
2
-20 lug nuts (Ref 8). Put slotted jam nut (Ref 6), cotter pin
(Ref 4) and dust cap (Ref 7) on axle end.
5. Check all nuts and be sure they are tight.
6. Take the wire harness and hook the female space connectors to the male spade connectors on the brake
assemblies. Run wire harness up side of main frame to front of machine. Hold wire harness in place with
the tie straps.
7. Dealer must provide the connector that hooks to the tow unit. Place one side of connector onto wire
harness, connect the other half to the tow unit.
8. Check all connections and hardware. Test brakes before putting machine into service.
This unit is not intended for highway use.