Smithco Spray Star 1100e 10-500-A Parts & Service Manual - Manual (Page 59)

57
Accessories
HOSE REEL PLUMBING PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 15-743 Electric ball Valve 1
2 15-742 Inlet Cover 1
3 15-740 50 Series Clamp 3
4 15-748 Reducer Coupling 1
5 15-736 #50 Elbow Coupling 1
6 15-738 Flanged Ball Valve 1
7 15-749 Hose Barb 1
INSTALLATION INSTRUCTIONS
1. On the top of the Electric Spray Control Valve (Ref 1) you will find a cover. Remove clamp, o-ring and
cover. Install a 15-748 reducer (Ref 4) in place of the cover you just removed. Reinstall clamp and o-ring
and tighten. The cap will not be used again.
2. Install a 15-736 Elbow onto the top of the reducer with a 15-740 clamp (Ref 3) and O-ring. Rotate it 90° so
it points to the rear of the machine, then tighten clamp.
3. Install the 15-738 ball valve (Ref 6) onto the elbow using a 15-740 clamp and O-ring. Tighten with the
handle on the top or side.
4. Install the 15-749 Hose Barb (Ref 7) onto the open end of the ball valve with a 15-740 clamp and o-ring.
Tighten.
5. Route the orange 3 /
4
" hose fro the hose barb to the hose barb on the hose reel and secure with a 18-040
Hose clamp.
6. Secure the orange hose to the machine with a nylon tie strap.
HOSE REEL ADJUSTMENTS
OPERATIONAL CHECK:
1. Pull hose off drum at least one full revolution. A clicking noise should be heard from locking mechanism.
2. Let the hose retract.
3. Pull the hose off until the first click is heard. Drum should lock when the hose tension is removed.
4. Continue pulling the hose, no more than one revolution, until no clicking is heard. Hose should rewind
when tension is removed.
HOSE REPLACEMENT PROCEDURE:
1. Facing swivel, turn the hose drum clockwise until all of the hose is removed from the drum and the drum is
held by locking mechanism. Make sure spring is locked.
2. Remove hose clamps and disconnect hose from swivel. Remove old hose.
3. Insert new hose through roller guide, connect to swivel and reinstall hose clamps. Use spring guard over
hose to protect the hose from being cut by the drum.
4. Remove check ball from old hose and install on replacement hose.
5. Carefully, keeping the tension on the hose, pull the hose to release the locking mechanism. Let the hose
wind on the drum.