Smithco Supreme 35-000 (sn 101978) Parts & Service Manual - Manual (Page 105)

103
Accessories
SPIKER LIFT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-357 Hydraulic Cylinder 1
HNJ-34-16 Jam Nut 3 /
4
- 16 1
2 13-366 Cylinder Extension 1
3 13-382 Cylinder Lift Frame 1
4 13-658 Right Pivot Bracket 1
5 13-659 Left Pivot Bracket 1
6 HB-12-13-150 Bolt 1 /
2
- 13 x 1 1 /
2
4
HW-12 Washer 1 /
2
4
HWL-12 Lockwasher 1 /
2
4
HN-12-13 Nut 1 /
2
- 13 4
INSTALLATION INSTRUCTIONS
1. To mount Spiker onto the Supreme you must remove the rake lift.
2. On all Supremes you have to unhook the speed boss arm before removing the rake lift. Completely
remove the linkage yoke, ball joint and linkage rod from machine. The speed boss does not need to
function when using the Spiker.
3. Set the spiker behind the machine. Bolt the Spiker to the main frame using the inside holes on the pivot
brackets (Ref 4 & 5). Use the 1 /
2
- 13 x 1 1 /
2
bolts, washers, lockwashers and nuts (Ref 6).
4. Thread the cylinder extension (Ref 2) all the way onto the cylinder (Ref 1). Tighten down with jam nut.
5. Using the second hole from the end of the cylinder extension, hook the cylinder extension (Ref 2) to the
bottom hole on the cylinder tab on the cylinder lift frame (Ref 3).
6. Compression springs should be tightened to 5 1 /
2
" for best result.
7. Test spiker for ground penetration. If there is too much ground penetration loosen the springs. If you
need more ground penetration, tighten springs.
The speed boss is not used with spiker. Leave unhooked.