Smart Avi RGB2VGA - Manual (Page 19)

INSTALLATION
19
3.3 System Setup
To install your RGB to DVI(/VGA) Converter:
1. Switch off all devices.
2. Connect your TFT directly to the device; connect a VGA screen by using the equipped
DVI-I to VGA adapter.
Connect the VGA monitor cable to the adapter; then plug in the adapter into the
device. Otherwise, the VGA mode is not detected, DVI output is generated and
there will be no picture on the screen (see also Diagnostic LEDs on page 21).
Under some circumstances, if your TFT supports both DVI and VGA through a
DVI-I cable, it might be necessary to use an additional DVI-I to DVI-D adaptor
to get a DVI output. Please contact technical support for this accessory.
3. Connect the graphic source to the input connectors as shown in Figure 1, using the
equipped 4xBNC-to-DVI adaptor. Please note, for connecting a CGA or EGA source,
connect the optional CGA-to-DVI adaptor or EGA-to-DVI adaptor instead of the 4x
BNC-to-DVI adaptor.
4. Connect the 6V power supply to power the unit.
Only use the power supply originally supplied with this
equipment or a manufacturer-approved replacement.
5. Power up the system.