Assigning a static ip address – Dynex DX-E201 User Manual
Page 12
12
Setting up the network card
4 Click the IP Address tab, then click Select Obtain an IP Address
Automatically.
5 Click OK. The Network Properties window opens again.
6 Click OK. When Windows asks you to restart, click Yes to complete
configuration of the Dynamic IP Address.
Assigning a static IP address
Note: DHCP (Dynamic Host Configuration Protocol) automatically assigns IP
addresses to computers on a network. If you have a DHCP-capable router, you
do not need to assign IP addresses.
To assign a static IP address:
1 Click Start, Settings, then click Control Panel. The Control Panel window
opens.
Dynex5x7-multi.book Page 12 Thursday, September 8, 2005 11:07 AM
See also other documents in the category Dynex Hardware:
- DX-M102 (16 pages)
- DX-SC71 (40 pages)
- DX-EBNBC (86 pages)
- DX-WGPDTC (24 pages)
- 2300-0248 (2 pages)
- DX-NNBC (33 pages)
- 2300-0247 (2 pages)
- DX-CF101 (1 page)
- DX-EF101 (2 pages)
- DX-WGRTR (196 pages)
- DX-ECDRW100 (50 pages)
- DX-UC104 (11 pages)
- DX-WGUSB (20 pages)
- DX-E401 (72 pages)
- DX-UC202 (7 pages)
- DX-BUSB (90 pages)
- DX-HDEN20 (12 pages)
- DX-CDRW52 (47 pages)
- DX-PCIGB (20 pages)
- DX-E101 (44 pages)
- DX-WEGRTR (200 pages)
- DX-2P2C (2 pages)
- DX-ECFW (16 pages)
- DX-HDEN10 (12 pages)
- DX-M110 (8 pages)
- DX-FC103 (2 pages)
- DX-E202 (12 pages)
- DX-E102 (16 pages)
- DX-CRMN1 (16 pages)
- DX-PHD35 (2 pages)
- DX-PHD35 (12 pages)
- DX-WGNBC (24 pages)
- DX-IF101 (1 page)
- DX-FC202 (1 page)
- DX-NRUTER (2 pages)
- DX-M100 (2 pages)
- DX-E402 (71 pages)
- DX-ECOD1 (16 pages)
- 5232IM (19 pages)
- DX-WGPUSB (22 pages)
- DX-NUSB (2 pages)
- DX-EBDTC (2 pages)
- DX-ESATL (48 pages)
- DX-ESATAP (52 pages)