Sierra Video UDC-161 - Manual (Page 23)

UDC-161 Owner’s Manual
• (V 2.2)
Page 23 of 36
Factory Default Settings
The factory default settings are as follows
1) The proc module has all parameters are set to unity.
2) The audio mapping is for simultaneous embedding and de-embedding. Discrete AES inputs 1-16
are mapped to embedded audio outputs 1-16. Embedded audio inputs 1-16 are mapped to discrete
AES outputs 1-16
3) Audio gain is set to 0dB and polarity is set to normal on all channels.
4) The Frame Sync is disabled, reference 1 or 2 must be chosen to enable the frame sync.
5) The Scaler is enabled and both SD and HD are set to be the same as input and half rate 720p is
turned off.
6) Aspect ratio is set to 1.0HV (No Correction)
7) AES SRC Bypass, Zero Delay Audio Embedding, and Low Latency Audio Passthrough are all
disabled.
AES IN/OUT Switch Settings
Switches S11 – S14 determine whether the AES IN/OUT ports on AES I/O 1-4 are set to input AES or
output AES.
1) Switching S11 up configures AES I/O 1 as AES IN, switching S11 down configures AES I/O 1 as
AES OUT.
2) Switching S12 up configures AES I/O 2 as AES IN, switching S12 down configures AES I/O 2 as
AES OUT.
3) Switching S13 up configures AES I/O 3 as AES IN, switching S13 down configures AES I/O 3 as
AES OUT.
4) Switching S14 up configures AES I/O 4 as AES IN, switching S14 down configures AES I/O 4 as
AES OUT.