Sierra Video DFR-8300 - Manual (Page 28)

3-2
• DFR-8310 Series Setup
DFR-8300 Series User Manual (Rev. 2.0)
Rear Modules for the DFR-8310 Series Frames
Depending on the frame model you purchased, there may be variations in the Rear Modules connected
to it. If the frame was ordered with cards requiring a Rear Module, the appropriate modules will be
installed at the factory or included with the card modules. You must have a Blank Rear Module (R1-
BLANK) installed when the slot does not have an openGear card installed. This helps to ensure proper
frame cooling and ventilation.
• DFR-8310 and DFR-8310-C frames come without pre-installed rear modules.
• DFR-8310-BNC and DFR-8310-C-BNC frames come with pre-installed with ten 10-
BNC Rear Modules.
Consult the installation section of each card’s manual for Rear Module cabling designations. Each card
also comes with the required Rear Module Label to place on the Rear Module.
Rear Module with 6 BNCs
and 4 AES Connectors
Standard rear Module with
10 BNCs
Figure 3.1 Examples of DFR-8310 Rear Modules
For More Information…
• on the Rear Module required, refer to the User Manual for your specific openGear
card.
• on installing Rear Modules, refer to the section “Rear Module Installation”.