Seaward Supernova XE - Manual (Page 44)

How to perform Manual Tests
34
Use the cursor keys to highlight a Location name and press Enter to
select the desired option.
Note
Default settings for Sites and Test Sequences are pre-loaded
into the Tester. See ‘How to use Setup’ to change these
settings.
Select Manual Test
Use the appropriate number key from the table to select a specific
test or use the cursor to highlight the desired option.
Performing a Manual Test
After selecting the appropriate test the tester displays a screen from
which you can set test parameters.
The user can change an individual setting when the icon is shown
inverted. Use the left and right cursor keys to highlight a field on the
display. Then use the up & down cursor keys to change the variable
in the selected field.
When an icon is shown inverted use the left and right cursor keys to
highlight a field on the display. Then use the up and down cursor
keys to change the variable in the selected field.
When the connection icon is flashing you cannot change any
settings.
note
You cannot change the settings for a test if you have
performed that test from within an appliance sequence. For
example after selecting Create Appliance No you can only
change the Earth Bond settings on the first Earth Bond test,
all subsequent Earth Bond test will conform to the same
settings.
Press the Enter button to start the test.
Press the Red button to abort the test at any time.