Sea Eagle SE-9 Motormount Boat (SE9) User Manual

Page 6

MB-80 Electric Pump

(OPTIONAL)

The MB-80 electric

pump inflates the SE-9

in a matter of minutes.

This electric pump

works using the 12V

power outlet in your car

or with the optional,

Minn Kota Power Cen-

ter accessory.

First, check that the

pump is switched OFF

before inserting the

power adapter into your

car’s power outlet.

_STOP

Directly insert the pump

(nozzle) into the valve

fill port. Please note the

valve adapters and

black tube that come

with the MB-80 are not

necessary for Sea

Eagle Boats.

Battery Connector

(OPTIONAL)

You can also power

your MB-80 using the

optional battery con-

nector which will allow

you to use the pump

while connected di-

rectly to a 12V car or

marine battery.

Assembly

Lay the boat out on a

flat area free of haz-

ards. If the package

you purchased includes

only seats and no

motor mount, follow

only the steps below

that apply.

If not installed already,

insert the inflatable

floor with the valve fac-

ing up and the edges

tucked under the sides.

Motor Mount Set

(OPTIONAL)

If you have the motor

mount set, layout the

items as shown here.

This set consists of

two rods with retainer

pins, motor mount

block and mounting

hardware.

Insert the motor mount

bar through the grom-

mets on top of the boat

and through the grom-

met on the bottom. Se-

cure the bottom with

the buttons. Repeat

with the other rod.

SeaEagle.com/Instructions

WARNING: Always connect the red clip to the positive pole

and the black clip to the negative pole. Cross connecting

wires could damage both the pump and boat.