Sea Eagle SE-9 Motormount Boat (SE9) User Manual
Page 5
One-Way Air Valve
Locate the five white
valves that come in a
bag packed with the
boat. This bag also
contains the Inflation
Monitor which will b
needed later.
Lay out the boat and
place the retainer rings
over the valve bases.
Stretch the rings if they
are too tight to fit over-
the base.
Screw the valves into
the bases. Be sure to
tighten firmly for a good
seal. Repeat valve in-
stallation for the floor
and optional inflatable
seats. For floor and
seats, adjust the blad-
der so the valves are
centered in their open-
ings.
Foot Pump
Unclip the pump by
pressing the halves to-
gether. Connect the
hose to the port marked
INFLATE.
Select the short round
adapter which is teth-
ered to the end of the
hose. Push the end
with the ears into the
hose and twist to lock.
Included with the
valves and repair kit is
a clear plastic “Inflation
Monitor”. This 10cm
scale is used to deter-
mine when the boat
has sufficient air.
Chambers 1 and 3
have the scale printed
on them for comparison
with the Inflation Moni-
tor.
Floor Drains
Two drains with
threaded caps are lo-
cated under the inflat-
able floor. They can be
used to drain the boat if
it becomes filled with
rainwater. Tighten them
before inflating floor.
Air compressors that
are designed for other
uses like tire inflation
(usually around 50 PSI)
can easily harm your
Sea Eagle which has a
much lower working
pressure. It’s for this
reason we recommend
only using Sea Eagle
electric pumps.
4
Motormount Boat |
INFLATION:
INFLATION:
Valves, Pumps & Assembly