Sea Eagle SE-9 Motormount Boat (SE9) User Manual

Page 11

DEFLATION

Deflation is as easy as

3, 2, 1. Deflate in the

reverse order chamber

3, then 2, then 1, and

finally, the floor! If the

order is reversed, air

will be trapped in

chamber 3, and cham-

ber 1 will then have to

be reinflated.

After unscrewing the

valves, most of the air

should be out, squeeze

out any trapped air.

Make sure you remove

any accessories like

the motor mount and

bench seats. Fold one

side of the boat until it

overlaps the floor.

Pull the other side over

the first until it overlaps

the boat as shown.

A) Fold the aft end over

approximately a third of

the way up the boat.
B) Fold the front of the

boat over the last fold.
C) Fold in half.

CLEANING & PROTECTING

Water collects under the sides of the floor of the boat. To

drain, loosen the drain valves in the stern of the boat and

elevate the front so water runs down and collects in the

stern. Turn boat over and lift the back so waterspills out.

Towel dry the lowest areas.
Dry after each use to avoid mold. While washing or rins-

ing: close the valves so that water cannot not enter the

chambers. Sea Eagles can be cleaned very effectively with

general purpose cleaning products and a scrub brush.
Protection from the Sun and Heat

Avoid leaving it in direct sunlight when ashore. Tempera-

tures on a beach, dock, davit, etc., can get very high which

could affect the vinyl or glue.

Excessive exposure to sun and heat can cause your boat

to become sticky or cause the glue to fail. 303 Protector &

3M Marine Cleaner combines cleaning and sun protection.

Aerospace Protectant

(OPTIONAL)

Apply to the vinyl every

3-5 weeks. Protectant

preserves the vinyl and

makes it easier to keep

the Sea Eagle clean.

Cleaner & Restorer

(OPTIONAL)

3M Marine Cleaner not

only clean various

stains off of your boat, it

also helps restore the

fabric to its original con-

dition.

Motormount Boats |

DEFLATION, CLEANING & PROTECTING