Scotsman SCE170 - Manual (Page 28)

Water Distributor
The water distributor tube will typically not require
any service beyond removal for cleaning. If
needed, remove the water distributor by:
1. Remove the hood.
2. Remove lower right front grill.
3. Switch master switch to OFF.
4. Loosen hose clamp at water distributor inlet (on
left).
5. Remove the two wing nuts holding the
distributor to the evaporator.
6. Lift water distributor off the studs.
7. Pull the inner distributor tube out of the outer
distributor tube and clean out all holes.
To reassemble.
8. Align the tube so that the inner distributor tube’s
holes are opposite the outer distributor tube’s
holes.
9. Place the end caps onto the water distributors.
10. Place the distributor tube onto the mounting
studs:
NOTE: The Outlet Holes Face Down, Towards
The Evaporator.
11. Replace the wing nuts, hose and hose clamp.
12. Switch the machine back on and check the
water flow.
13. Replace the hood.
Evaporator Stud
Wing Nut Inner Distributor
Tube Water Outlet
Outer Distributor
Tube
Water Oulet
Evaporator
Bracket Side View of the Water
Distributor
End Cap
Outer Distributor
Tube
Evaporator Bracket
Inner Water
Distributor Tube
Hose Clamp
Water Inlet
Hose
Water Distributor Assembly
Wing
Nut
SCE170
October 1998
Page 28