Scotsman FM2400RH - Manual (Page 3)

FOR THE INSTALLER
Select the Location:
The unit can only be installed indoors
within the limitations described on
page 2.
The ice machine will have to be
connected to the buildings R502
refrigeration system, check to be
sure that the system has enough
extra capacity to handle a minimum
of additional 16,000 BTU’s per hour
@ 110
0
F. liquid line temperature
(assume a 0
0
F. evaporator
temperature).
Storage Bin:
Scotsman’s B90 will be the
presumed bin of choice. If using the
bin extension BX87, install heavy
duty leg kit KLP4 and place the bin
into position.
Remove the paper tape from the bin
edge gasket, and install the bin
extension onto the B90.
Remove the paper tape from the bin
extension top edge, and using a
mechanical lift, install the FM2400RH
onto the top of the storage bin
assembly.
Fasten the ice machine to the bin
using (4) 5/15-18 2.5" cap screws.
Level the assembly by:
a. Turning the leg levelers in or out
on the standard legs.
b. Use shims under the heavy duty
legs of the KLP4.
Locate the Nameplate: The
nameplate is located on the back
panel of the machine, and contains
the electrical characteristics
particular to the unit being installed.
Refrigeration Installation:
The skills of a refrigeration technician are required
to connect the ice machine to the buildings
refrigeration system.
////////////////////////////CAUTION/////////////////////////////
The FM2400RH-32B comes with a dry nitrogen
holding charge. Purge and evacuate before
connecting to a refrigeration system.
////////////////////////////////////////////////////////////////////////
Local Codes must be observed.
A P-trap should be installed where there will be
more than 10’ of vertical rise in the suction line.
FOR THE ELECTRICIAN
CONFORM TO ALL APPLICABLE CODES
TYPICAL INSTALLATION: ALLOW ROOM FOR SERVICE ACCESS
FM2400RH
BX87 BIN
EXTENSION
B90 STORAGE BIN
FM2400RH
August 1994
Page 3