beautypg.com

Water seal, Fm2400rh, Removal and replacement – Scotsman FM2400RH User Manual

Page 23

background image

/////////////////////////////WARNING///////////////////////////
Disconnect the electrical power to the machine
at the building source BEFORE proceeding
with any repair.
//////////////////////////////////////////////////////////////////////////
To Remove the Water Seal:
(Assuming all steps to remove the auger have
been performed.)
1. The gearmotor/evaporator assembly will have to
be exposed.
2. Remove the 4 hex head cap screws holding the
evaporator to the gearmotor assembly. Lift the
evaporator up and off of the gearmotor.
3. Remove the snap ring or wire retainer from the
grove under the water seal.
4. Pull or drive out the lower half of the water seal.
To Replace the Water Seal:
1. Lubricate the water seal with water, and push
the water seal into the bottom of the evaporator

slightly past the grove for the snap ring.
2. Replace the snap ring and pull the water seal
down against it.
3. The part of the water seal that rotates with the
auger must also be replaced. Remove the old part
from the auger and clean the mounting area.

4. Place a small bead of food grade silastic sealant
(such as 732 RTV or Scotsman part number
19-0529-01) on the area of the auger where the
water seal is to be mounted.
5. Carefully push the water seal (rubber side
against the auger shoulder and the silastic.)
/////////////////////////////CAUTION///////////////////////////
Do not get any silastic onto the face of the seal.
/////////////////////////////////////////////////////////////////////////
6. Allow the auger and seal to air dry until the
silastic is dry on the surface.

7. If the original water seal was leaking, it
would be a good idea to inspect the interior of
the gearmotor.

REMOVAL AND REPLACEMENT

WATER

SEAL

RETAINING

RING

PLACE FOOD

GRADE SEALANT

HERE

FM2400RH

August 1994

Page 23

This manual is related to the following products: