Scotsman HID312AW - Manual (Page 14)

HID312AW, HID525AW and HID540AW
Installation and User’s Manual
March 2015
Page 14
Maintenance and Cleaning - Dispensing bin and ice level controls
The ice storage bin and rotor must be cleaned and
sanitized on a regular basis, at a minimum when the
ice making system is cleaned. Hand tools and hand
protection like rubber gloves are recommended for
this procedure.
Note: Some steps overlap with the procedure on the
next page. This procedure can be independent of the
ice making system cleaning or can be part of it.
1. Remove upper front panel.
2. Remove top panel.
3. Shut machine off.
4. Vend or melt out all ice.
Note: Only add 16 oz water to the bin at a time, as
excess water will drain out the spout.
5. Disconnect ice level control at harness.
6. Unplug or disconnect unit from electrical power.
7. Remove ice storage bin cover, set aside.
8. Remove agitator bar (rotate CCW), set aside.
9. Remove 2 thumbscrews & chute cover, set aside.
10. Lift up and remove dispense rotor, set aside.
11. Mix a solution of ice machine scale remover, such
as Scotsman Clear 1 and potable water per the
directions supplied with the scale remover.
12. Use a clean cloth and wash all the interior
surfaces of the bin and the bin cover, agitator
bar, chute cover and dispense rotor with the ice
machine scale remover solution. Rinse with clear
water.
13. Mix a 2 gallon solution of locally approved
sanitizer. A possible sanitizer solution is one
packet of Stera Sheen Green Label and 2 gallons
of warm (95 o to 105 o F.) potable water.
14. Use a new clean cloth and wash all the interior
surfaces of the bin and the bin cover, agitator bar,
chute cover and dispense rotor with the sanitizer
solution.
15. Return all parts to their original positions and
secure them with their original fasteners.
16. Reconnect electrical power and restart the
machine.
Moving parts hazard.
Risk of personal injury.
Disconnect electrical
power before
proceeding.
Dispense
Rotor
Dispense
Drive Pin
Agitator
Chute Cover