Desa DVF32TMHST - Manual (Page 18)

- 17 - For more information, visit www.desatech.com
Read these instructions completely before installing this conversion kit. Before proceeding, make sure the gas control valve is on the
"OFF" position, all electrical power to the appliance is OFF, and the fireplace is cool to the touch. Conversion Kit model PC-
DVF32TMHSTPN is required for this conversion. Please check the contents before beginning the conversion.
Parts included with this kit:
Part
No. Description Quantity
110873-01
Instruction Sheet 1
108085-02 Pilot Orifice, LP (30) 1
23104 Main Burner Orifice, LP (#51) 1
14488 Gas Valve Regulator, LP 1
Tools Required:
• Torx T20 Slotted Screw driver
• 5/32” Allen Wrench
• 11/16" Open End / Adjustable Wrench • 5/16" Socket or Nut Driver
• 7/8" Open End / Adjustable Wrench • #2 Phillips Screwdriver
• Thread Sealant • High Temperature Silicone Sealant
(Resistant to Propane/LP Gas) (GE RTV 106/Locktite RTV81585)
ACCESSING THE FIREPLACE
You may access the burner system from either side of the unit.
1. Remove the upper and lower louver panels by pulling the four spring latches towards the center while simultaneously pulling the
louver assembly away from the unit. The latches are located at each end just below the uppermost and just above the lowermost
louvers. See figure 33.
2. Remove the screen rod, if installed, by sliding the screen rod to the left or the right until one of the rod ends is free and completely
remove the screen assembly from the fireplace.
3. Open the glass door by releasing the two pairs of latches located on the top and bottom of the firebox (see figure 33). You may
need a screwdriver to extend the spring-loaded clasp over the catch on the door flanges. Use caution when opening these latches.
Figure 33 Accessing the Fireplace
CONVERSION KIT – NATURAL GAS TO PROPANE
SHOULD BE DONE BY A QUALIFIED TECHNICIAN