ROTEL RTC965 - Manual (Page 19)

RTC-965
19
Note: To use an outdoor antenna, connect its 300 ohm twin-con-
ductor wire to the G and AM terminals in place of the loop an-
tenna, only after a professional contractor has installed the
antenna system in accordance with local electrical codes.
FM Wire Antenna
35
The RTC-965 includes a wire antenna to receive FM signals. In
many countries (including the USA), this antenna is a T-shaped
twin-conductor 300
Ω
antenna. Remove this antenna from the box
and connect its two conductors to the two screw terminals on the
supplied 300
Ω
to 75
Ω
adaptor. Connect the coax plug on the con-
verter to the FM 75
Ω
antenna connector on the RTC-965.
For best reception, unfold the T-shaped wire antenna. There are
eyelets at both ends of the T, which allow tacking the antenna to a
wall, if desired. Experiment with positioning for best reception.
In some countries, the RTC-965 may be supplied with a single wire
FM antenna terminated by a 75
Ω
coax connector. If your unit is
supplied with this antenna, connect it directly to the FM 75
Ω
an-
tenna connector.
Note: To use an outdoor antenna, connect its 75 ohm coax lead
wire (or 300 ohm twin-conductor wire and 300 ohm to 75 ohm
adaptor) to the FM 75
Ω
connector in place of the indoor wire an-
tenna, only after a professional contractor has installed the an-
tenna system in accordance with local electrical codes.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Rear Panel AC Power Connections
AC Input 40
Your RTC-965 is configured at the factory for the proper AC line
voltage in the country where you purchased it (either 115 volts AC
or 230 volts AC with a line frequency of either 50 Hz or 60 Hz). The
AC line configuration is noted on a decal on the back of your unit.
Plug the supplied cord into the AC INPUT receptacle on the back
of the unit.
AC Convenience Outlets 33
Two outlets let you plug AC cords from source components or
other accessories into the back of the RTC-965 so that they will be
turned on and off automatically. The outlets are powered when-
ever the RTC-965 is fully active. They are off when the RTC-965 is
in STANDBY mode.
Note: The rear panel AC outlets are only available on 115 Volt ver-
sions of the RTC-965 and not available on 230 Volt models.
Remote External Sensor Jack 34
This 3.5 mm mini-jack receives command codes from industry-
standard infrared receivers (Xantech, etc.) via hard-wired con-
nections. This feature could prove useful when the unit is installed
in a cabinet and the front-panel sensor is blocked. Consult your
authorized Rotel dealer for information on these external repeat-
ers and the proper wiring of a jack to fit the mini-jack receptacle.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
On-Screen Display / Configuration
The RTC-965 features two on-screen systems to help operate the
system. The first consists of simple status displays that appear on
the TV screen whenever primary settings (Volume, Input, etc.) are
changed. These status displays are self-explanatory.
A more comprehensive On-Screen Menu system is available at
any time by pressing the MENU button on the front panel or the
remote control. This system includes intuitive menus that guide
you through the setup and operation of virtually every function
and setting of your RTC-965.
Navigation Buttons 41 46 49 50 52 53
PLAY
SEL
PAUSE
C. DELAY
STOP
DYNAMIC
SEARCH –
SEARCH +
BAND
T / V
CH
GUIDE
RECALL
MENU
PRE
CH
SURROUND + ON SCREEN
TRACK – TRACK +
DISC 1 DISC 2 DISC 3 PROG
DISC 4 DISC 5 DISC 6 TIME [REVIEW]
CLEAR [SCAN]
RANDOM [REPEAT] >10
OPN/CLS SUR-DELAY
UP DOWN
1 2 3 MOVIE FILT
4 5 6 5.1 CH
7 8 9 SELECT
10 0 ENTER BACK
MUTE
POWER
VOL
SAT TV VCR CBL
41
49
46
50
52
53
BACK
ENTER
UP
DOWN
MENU
VOLUME
The following buttons are used to navigate the On-Screen Menu
system:
MENU Button: 49 To display the MAIN screen. All other menus
are reached from this menu. If a menu is already visible, push this
button to cancel the Display.
DOWN/UP remote control buttons 50 46 or NUMERIC Keypad
front panel buttons ( ) 5 : To move up and down in the lists
that appear on the On Screen Menu system.