How to realize single image switching, How to scale the image, How to crop the image – RGBLink CP 3096H Quick Start User Manual

Page 14

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

area, then push the [TAKE] button, the signal will be switched to LED display.

For example, switch VGA to LED display, first push the [VGA] button in PREVIEW area, then push the

[TAKE] button or T-bar in effects switch control area, the LED display will show VGA signal.

System default the switch time is 1 seconds for [TAKE] button, if need to adjust the fade time, turn the

knob in transition time control area, and set according to actual need, push the [TAKE] button again, the

signal will be switched to the LED display with the adjusted time.

User can also switch the signal by pushing the signal button in PROGRAM area, but the signal in

monitor will not change.

1. Push the [SCALE] button in function area and enter to the scale function menus.

2. Turn the knob, choose H SIZE or V SIZE and set according to actual need, user can adjust the items

by knob or number buttons, after setting, push the knob to confirm.

3. If image quality distorts by improper operation, it can be recover by reset.

1. Push the [CROP] button in function area and enter to the crop function menus.

2. Turn the knob, choose H SIZE, V SIZE, H POS or V POS, and set according to actual need, user

can adjust the items by knob or number buttons, after setting, push the knob to confirm.

3. If image quality distorts by improper operation, it can be recover by reset.

Note: The setting is only for the selected input signal.