Common questions and solution, 12v power interface poor contact, Power indicator light is off or blinks – RGBLink MSP 214 Quick Start User Manual
Page 2: Signal indicator light is off or blinks
MSP 214 DVI to Fiber
Function Block Diagram
Operating Principle
MSP 214 DVI to Fiber transmitter is connected to
computer, media player or HD camera, etc. User can
connect the DVI interface on MSP 214 DVI to Fiber
panel to PC with DVI cable, then connect the
computer or media player, and MSP 214 DVI to
Fiber transmitter to power supply. In order to avoid
the damage of device, please use the standard power
adapter. Fiber interface is used to connect to MSP
214 Fiber to DVI receiver.
Operation Manual
Function Block Diagram
Operating Principle
MSP 214 Fiber to DVI
MSP 214 Fiber to DVI receiver is connected to
television (monitor) or LED screen which has DVI
interface.
Connect the fiber interface to the other fiber interface
on MSP 214 DVI to Fiber transmitter with fiber
cable, and then connect the DVI interface on MSP
214 Fiber to DVI panel to display device.
In order to avoid damaging the device, please use the
standard power adapter.
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected]
MSP 214 Quick Start
Rev 1.3
Page 2 of 2
Common Questions and Solution
output wire are normal, the interfaces are in good
connection;
3. If above without problem, then the signal
indicator is damaged.
Note: The indicator beside fiber interface is off
when the device is in normal operation. It will light
or blink if the fiber cable is in poor connection.
12V power interface poor contact
1. Check whether the power interface is in good
connection, if the interface is not tighten, screw
it again.
2. Check whether any problem with adapter head,
replace it if there is any problem.
3. Check the power connector is loose, if so, please
send to professional personnel for repair.
Power indicator light is off or blinks
1. Check whether plug in the power cord, and has
power supply;
2. Check whether the power cable is connected, and
in good connection;
3. If above without problem, then the power
indicator is damaged.
Signal indicator light is off or blinks
1. Check whether connect the DVI signal;
2. Check whether the input signal, input wire and