How to switch between input and output channel, How to switch one input to all outputs – RGBLink DXP D1616 Quick Start User Manual

Page 8

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

DXP D1616, specific operations are as follows:

1. If choose “AUTO TAKE ON”, push any button on output area on the front panel, for example,

choose [5] as the output channel.

Then push any button on Input area on the front panel, for example, choose [3] as the input

channel, the signal of output channel 5 will be switched to the signal of input 3.

2. If choose “AUTO TAKE OFF”, push any button on output area on the front panel, for

example, choose [5] as the output channel.

Then push any button on input area on the front panel, for example, choose [3] as the input

Channel. After setting, push the [TAKE] button to confirm.

Note: Input channel: The signal that will be switched to output channel.

Output channel: The signal that connected to display device.

The number [1]~[16] means channel 1~16.

1. If choose “AUTO TAKE ON”, push the [ALL] button on the front panel.

Then push any button on input area on the front panel, for example, choose [3] as the input

channel, all the signal of output channel will be switched to the signal of input 3.

2. If choose “AUTO TAKE OFF”, push the [ALL] button on the front panel.

Then push any button on Input area in the front panel, for example, choose [3] as the input channel.

Push the [TAKE] button to confirm, all the signal of output channel will be switched to the signal

of input 3.