How to realize signal auto take, How to lock the front panel, How to realize hot backup – RGBLink DXP D1616 Quick Start User Manual

Page 11

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

2. Push the [MENU] up arrow button or [NEXT] down arrow button, and choose [AUTO TAKE].

3. Push the [TAKE] button to confirm, and enter to the auto take setting. Push the [NEXT]

button to choose “ON” or “OFF”, then push the [TAKE] button to confirm. System default the

status is “ON”, and when switch the signal, user need not to push the [TAKE] button.

1. Push the [MENU] button on the front panel, and enter to the menu items.

2. Push the [MENU] up arrow button or [NEXT] down arrow button, and choose [LOCK].

3. Push the [TAKE] button to confirm. Push

the [NEXT] button to choose “ON” or “OFF”, then

push the [TAKE] button to confirm. Push the [MENU] button for 3 seconds to unlock panel.

1. Push the [MENU] button on the front panel, and enter to the menu items.

2. Push the [MENU] up arrow button or [NEXT] down arrow button, and choose [HOT BACKUP].

3. Push the [TAKE] button to confirm, and enter to hot backup function setting. Push the [NEXT]

button to choose “ON” or “OFF”, then push the [TAKE] button to confirm.

Inputs 1 ~ 8 are any combination of backup, it will recall another backup if one signal has

problem. The detailed parameters can be set on windows control program, and invalid for

button operation.