How to use black out, How to realize the blend setting – RGBLink CP 3072 Quick Start User Manual

Page 15

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

SELECT: Choose the channel for operation, user can choose the channel of A BUS or B BUS.

Black out descriptions:

Black signal realizes one-key-touch to a black screen.

CP 3072 provides black effect processing for program output and preview output, with cut black

effect. Operation is as below:

Push the [BLACK] button in A-BUS/PGM bar, the button light is on, then the program output is

cut to black. Push the [BLACK] button in B-BUS/PST bar, the button light is on, then the

preview output is cut to black. The effect is shown as below:

1. First, set PIP mode, or user can not set blend.

2. Push the [BLEND] button in BLEND Operation Area, and enter to the blend menus.

3. Turn the knob, and choose , push the knob to confirm. Turn the knob, choose

“ON”, push the knob to confirm.