RGBLink CP 3096 Quick Start - Manual (Page 14)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
13
How to Realize Single Image Switching
1. Boot the system default CV1 to the current input source (key lights), if need seamless switching other
source such as VGA, push VGA button.
2. Choose VGA buttons, button CV1 light is off, and VGA button lights, it can realize single picture of
input signal source switching (switch CV1 to VGA).The same method can switched CV2, CV3,
S-Video, YPbPr, HDMI and SDI.
Note: Seamless switch: means signal switch will not appear any flash point, black, shaking or delay.
How to Scale the Image
1. Push [SCALE] button in function area to enter the scale function menus.
2. Turn the knob, choose H SIZE or V SIZE and set to default values, (the default value can also be
set via the number button), after setting, push the knob to confirm.
3. If the operation is wrong, turn the knob to adjust again, or choose “RESET” in [SCALE] for recover
system default, and reset the above items.
How to Crop the Image
1. Push [CROP] button in function area to enter the crop function menus.
2. Turn the knob, choose H SIZE, V SIZE, H POS or V POS, and set to default values, (the default
value can also be set via the number button), after setting, push the knob to confirm.
3. If the operation is wrong, turn the knob to adjust again, or choose “RESET” in [CROP] for recover
system default, and reset the above items.