RGBLink VSP 3550S Quick Start - Manual (Page 4)

VSP 3550 Quick Start
Rev 1.0
Page 4 of 4
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
display properly, please check whether there is input
signal, or if input wire interface is taken tight, output
wire interface is picked up tightly. If display normally,
check if sending card is normally working or need to
replace sending card test.
Large Screen Output Flash Point
Confirm if preview output is normal
Find a belt VGA input (best for DVI) display, connect
to the corresponding output port of processor, check
whether the signal is correct on the monitor. If display
normally shows and no flash point, please check
whether DVI outlets put tight or replace to DVI line of
sending card. If display flash point, please judge if
input signal, wire, and interface is normal.
Large Screen only Display Part of the Image
Signal need to scale
Press [SCALE] button in the processor and knob to
adjust the actual screen size of the screen, combined
with button[POS], including "H SIZE" and "V SIZE",
push the knob to confirm.
No Display in the Second Half Part of Large
Screen
Resolution is inadequate
Please make sure the points of the screen width and
height, choose the resolution to be bigger than screen
width by push button [MENU], and choose [OUTPUT
FORMAT] option, push the knob to confirm.
All Key Lights Light Simultaneously
Check if dial switches are normal
Power off, check if two red dial switches near CV are
upward. Reboot if they downward, and reboot. The
function of the red dial switched is for upgrade.