REMKO EFS 25 - Manual (Page 17)

The following diagram shows the maximum dispensing medium flow rate if the hot water temperature is 45
°C at the dispensing connection, after being mixed with cold water with a temperature of 10 °C. The hot
water temperature set on the controller is 60 °C.
A
B
[l/min]
[kW]
Friwa EFS 25
Fig. 9: Maximum dispensing medium flow rate
A: Dispensing medium flow rate [l/min]
B: Power [kW]
Boundary conditions:
Cold water temperature: 10 °C,
Example 1
Hot water temperature on the controller: 60 °C
Temperature in the buffer tank: 70 °C
ð Maximum dispensing medium flow rate: 31 l/
min, transmission capacity: 74 kW
Example 2
Hot water temperature on the controller: 60 °C
Maximum dispensing medium flow rate: 25 l/min
ð Temperature in the buffer tank: ~65 °C, trans-
mission capacity: 60 kW
17