REMKO EFS 25 - Manual (Page 10)

4 Design and planning
4.1 General Information
The fresh water station is a fresh water module
that heats domestic water according to the contin-
uous flow heater principle. In order to ensure fault-
free operation of the fresh water station, the
system must fulfil certain prerequisites. Before
installation, take some time for planning.
CAUTION!
Danger of scalding due to hot water!
Due to external circulation in the primary cir-
cuit, water with a temperature of up to 90 °C
can leak out at the dispensing connection.
– No external pumps are permitted to be
installed between the fresh water module
and the buffer tank.
– The fresh water module is not permitted to
be connected to a heating cycle distributor.
Installation example
The operating mode can be bivalent alternative.
This hydraulic diagram serves merely to assist in planning activities;
the hydraulic system on site must be planned and laid out by the installer!
Subject to technical changes!
D
A B C
EFS HGU
RES
M
AB
A
B
A42
Fig. 3: Fresh water station with optional circulation set and optional return distribution
A: Cold water
B: Hot water
C: Heater heating cycle
D: Circulation
REMKO fresh water station
10