REMKO HPS500 - Manual (Page 12)

12
REMKO
HPS 500, MPS 800, MPS 1000
2. Bend the clamping tongues inwards
at an acute angle.
Fitting the collars
1. Remove the collars from the
packaging in their delivered
condition.
The insulation must not be bent or
pushed in, as this risks damage (stress
whitening). Any stress whitening which
occurs through improper handling can
be carefully removed or minimised with
a hot-air blower.
Depending on the heating output
of the hot-air blower, it may be
necessary to maintain a minimum
distance between the insulation
and the blower. Naked flames are
prohibited.
! CAUTION
During operation, the tank
temperature must not consistently
exceed 110°C.
NOTE
When fitting the collars, please
note the following steps: