Remko – REMKO HPS500 User Manual
Page 10
10
REMKO
HPS 500, MPS 800, MPS 1000
To install the insulation, proceed as follows:
1. Open the packaging and lift the
insulation section with the holes in
it, with the matting on the inside,
over the connections. In order to
avoid danger to those under your
supervision (e.g. children suffocating),
all packaging must be disposed of
immediately or else cut up.
Fitting the insulation
2. Engage the section of insulation-with
no holes into the hooked closure
strip of the previously attached
insulation section.
3. Snap the supplied installation strip
cover over the hooked closure strip.
This will prevent the hooked closure
strip from opening during the rest of
the installation process.
4. After attaching the installation strip
cover, the insulation can be sealed
with the second hooked closure strip.
If the insulation consists of three
sections, repeat the two previous
steps.