REMKO RKV 13 C - Manual (Page 7)

7
Multifunctional display
The display is divided into 4 areas.
The operating mode is displayed in the upper area.
Operating mode display:
Dehumidification
Cooling (+ dehumidification)
Not assigned
Not assigned
Ventilation (only ventilation mode)
In the 3 lower areas, the following is displayed:
1. Selected temperature 2. Fan operation
3. Clock / Timer functions
Important information about switching off the unit.
à Under certain circumstances, the fan continues to
run for approx. 30 seconds after the unit has been
switched off. In this case, the red light on the unit is
illuminated.
à After the unit has been switched off, the condensa-
tion pump continues to run for approx. 7 minutes.
Checking signal transmission
Point the remote control at the receiver of the indoor
unit. Press the ON/OFF button once. The air-
conditioning unit now indicates proper reception by
beeping. At same time, the green light on the receiver
lights up.
Fan operation display
Customisation active?
Fan speed
Plate fin setting
Temperature display
Temperature
measurement unit
Selected temperature
Unit configuration
Unit address
Battery status
Clock / timer functions display
Daily program
Programmed shut-down
Programmed start-up
Time of day or programmed
on/off time
Night program
Switching the unit off - Button (7)
The air-conditioning unit is switched off with the button
(7) . To do this, the current settings must be illumi-
nated on the remote control display. If only the clock
can be seen, the button (7) must be pressed first. If
the unit does not switch off, this process must be re-
peated.
Switching the unit on - Button (7)
If the air-conditioning unit is to be switched on, only the
clock may be visible on the remote control display. If
other symbols are displayed, first press the button (7)
and then only the clock is visible.
To switch the unit on, press the button (7) and the
green light on the indoor unit lights up. The functions
stored in the remote control are displayed. The unit is
operated according to these functions.
The condensation pump switches after a brief delay and
is in continuous operation during cooling mode.
A beep indicates that signals are being transmitted from
the remote control to the unit. If, when the unit is
switched on, there is no acoustic signal and the green
light does not light up, this process must be repeated
(switch off the remote control / switch on the unit).
The following section describes how to adjust the re-
mote control and the indoor unit to the operator’s needs.
Setting the clock - Button 19
To use the Timer program, you must set the clock on
the remote control beforehand.
To do this, the button (19) must be pressed and held
down once for at least 5 seconds. The hours blink and
can be adjusted with the buttons and . The min-
utes are set the same way after the button (19) has
been pressed.
The clock is activated by pressing the button (19) again.
Important information about switching on the unit.
à The compressor starts approximately 3 min. after a
safety period has elapsed to prevent damage.
à To protect the compressor from further damage, it
always runs for at least 3 minutes before it switches
off.
à The air-conditioning unit only beeps when the signal
has been properly transmitted.